DSE7320 Auto Start Starting Controller

ACCESSING THE FRONT PANEL CONFIGURATION EDITOR
• Ensure the engine is at rest and the module is in STOP mode by pressing the Stop/Reset button.
• Press the Stop/Reset and Info buttons simultaneously.
• If a module security PIN has been set, the PIN number request is then
shown :
• Press , the first ‘#’ changes to ‘0’. Press (up) or (down) to adjust it to the
correct value.
• Press (right) when the first digit is correctly entered. The digit you have just entered will now
show ‘#’ for security.
• Repeat this process for the other digits of the PIN number. You can press (left) if you need to
move back to adjust one of the previous digits.
• When is pressed after editing the final PIN digit, the PIN is checked for validity. If the number is
not correct, you must re-enter the PIN.
• If the PIN has been successfully entered (or the module PIN has not been
enabled), the editor is displayed :
EDITING A PARAMETER
• Enter the editor as described above.
• Press the left or right buttons to cycle to the section you wish to view/change.
• Press the up or down buttons to select the parameter you wish to view/change within the currently
selected section.
• To edit the parameter, press to enter edit mode. The parameter begins to flash to indicate that
you are editing the value.
• Press the up or down buttons to change the parameter to the required value.
• Press to save the value. The parameter ceases flashing to indicate that it has been saved.
• To exit the editor at any time, press and hold the button.

ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
• The ‘running’ editor can be entered while the engine is running. All protections remain active if the
engine is running while the running editor is entered.
• Press and hold the button to enter the running editor.
EDITING A PARAMETER
• Enter the editor as described above.
• Press the left or right buttons to cycle to the section you wish to view/change.
• Press the up or down buttons to select the parameter you wish to view/change within the currently
selected section.
• To edit the parameter, press to enter edit mode. The parameter begins to flash to indicate that
you are editing the value.
• Press the up or down buttons to change the parameter to the required value.
• Press to save the value. The parameter ceases flashing to indicate that it has been saved.
• To exit the editor at any time, press and hold the button.

auto start unit

Auto Mains (Utility) Failure

brushless generator

DSE7320 Auto Start Starting Controller Images